Piston Vise

over 2 years ago
Piston Vise
Available on
Kent, WA Posts 1,379 Piston Vise

Wicked Fabrications all new Piston Vise for machining pistons the way you need them to fit !The very rigid, BILLET Aircraft aluminum, design can handle a bore size of 3.250 thru 5.125 !The piston is mounted onto a .750 diameter steel shaft through the wrist pin bore, then clamped into the Jaws to be located true and firmly ! Note: we use a thin wall bushing to go between the .750 diameter shaft and the actual pin bore on your piston !The vise jaws can be rotated in both X- and Y- Axis using the degreed marks right on the vise !You can use this vise on a drill press , on a mill or even on a rotary table !There are two slots milled into the bottom of the base for dogs to locate the vise on your mill table. Note: if your application uses a wrist pin of a smaller diameter than .750 , an optional shaft can be ordered !Call Brandon @ Wicked Fabrication 253-833-0445
$ 895 plush shipping
Tell him Tribal Thunder sent ya !

Nice 2008 Seadoo Speedster 150 ...
Spring Hill,KS,USA
2012 Sea Doo 180 CHALLENGER Supe...
Boca Raton,FL,USA
2008 Sea Doo 150 Speedster 50 HO...
2010 SEA DOO 230 CHALLENGER! 82 ...
Fort Lauderdale,FL,USA
2012 Sea-Doo 180 SE Used
Georges Mills,NH,USA