1971 20' Seacraft restored

about 4 years ago
1971 20' Seacraft restored
Available on

Listing for a close friend:
Entertaining the idea of selling my 1971 20' Seacraft Potter Hull, completely taken down to the hull and restored 5 years ago. With over two years in the rebuild and well over 20 thousand dollars invested, I never thought I would see the day that I would ever even consider selling. You don't have to be an avid boater to know the Potter Hull Seacraft reputation. These boats are highly sought after, rare, and no expense spared in her restoration. She will make the next owner very happy.
Located in Delaware
Completely restored, garage kept/covered 20' 1971/2008 Potter Hull Seacraft
18" Draft
7'6" Beam
16* deadrise at transom
2003 Yamaha 115 four stroke
30 gallon stainless below deck fuel tank
Organized binder full of maintenance, updates and receipts
1971 Potter Hull, taken down to bare bones, new stringers, floor, paint (nonskid floor), fuel tank, and transom raised to accommodate a 25" motor. Legendary ride, wont find a smoother riding mono hull in its class, I fish a tight chop in the Delaware Bay most of the time and can run comfortably. Have been as far 15 miles in the ocean wreck fishing multiple times.
2003 Yamaha 115 Four Stroke, trouble free. Purchased off a freshwater boat with 30 hours on it. Now 350+/- (will check exact tomorrow) hours. 30 knot cruise @ 4800 RPMS 39-40 knot WOT @ 5600 RPMS, 3-blade aluminum yamaha propeller, can squeeze a few extra knots out of it with re-propping, many run 5800-6000rpms with these motors. Religiously flushed after use, 3.5-4mpg. Treated with Startron every tank. Maintenance log and service history available.
Raymarine E7d, with airmar transducer. Marine VHF with 6' Shakespeare Antennae. Top of the line marine head unit with two 6.5" JL Audio speakers.
Brand new Load rite single axle aluminum I-Beam Bunk trailer with less than 200 miles on it, all LED lighting and stainless steel hardware used for long lasting reliability. The boat loads and unloads with ease and can be done by yourself
All new wiring done with heat seal connectors then heat shrink over top for double protection. Dual batteries (8 months old) with perko battery selector. Blue under gunnel lighting. Dual bilge pumps. All new fuel lines, valves, sending unit, fuel pick up, water seperator, perko vented gas tank vent. Moeller fuel gauge. Southco stainless flush mount latches ( front two compartments have locking perko latches). Flush mount compass. Stainless cooler tie down kit. SeaDeck bolster pads. Tempress hatch installed for access to below deck tank. Custom boat cover.
Contact Information
Kevin Knotts
: (302) 299-9374
Yes it comes with the steering wheel
Some action shots..
Build Pics and Details:
Deck: 3/4" Marine Plywood, epoxy resin x2 coats both sides and edges, followed by fiberglass matt, followed by West System Epoxy.
Transom: From the outside apporach: 1.5 oz mat> resin> double 3/4" Marine Plywood with 1.5oz mat in between>1.5oz mat over core>1708>1.5oz mat>1708.
Hull: Foam removed, stringers replaced, glassed.

20' Seacraft
Fort Lauderdale,FL,USA