[NB/NA] InfinitFab Carbon Exige seat + NC mounts

over 3 years ago
[NB/NA] InfinitFab Carbon Exige seat + NC mounts
Available on

And now for something different: I've received a lot of requests offering to buy this seat from me.
I figured I would officially offer it up for sale, as i'm going to try something a bit different this year.
For sale:
InfinitFab Carbon Exige replica seat
RyokuRob NC lotus seat mounts
Complete bolt in package: Asking $800 without the harnesses.
With current Racequip 3" harnesses and all hardware (sans seat belt receiver), ready to bolt in: $900Condition: Good condition, there are a few rub marks from the plastic panels on the back of the seat.
They are not visible when installed.Questions:
1. Will you separate: I will not separate the mounts and the seat.
Neither has value to me without the other.
You can buy both and resell either at your convenience
2. Seperation of the fabric: It did happen in high heat.
I've re-glued the fabric to the shell, but i don't guarantee it'll stick forever.
I'm not an upholsterer, but we all experienced it that bought these.
It MAY need to be reglued down the road.
3. Shipping:
You can pickup locally, or we can do Fedex or grey hound shipping.
Shipping rates can be calculated from the DC area.
Shipping is not included.
4. Will this fit a NA/NB:
The seat will fit any Miata.
The mounts are NC specific.
See #1.
NA/NB mounts are not rare, these are extremely rare and short run production.
5. I can't find info on this seat+mount: This is the very last seat Infinit sold before leaving the business.
From my research, these seats are made in the same factory that SEIBON uses.
I can explain further in a PM if you are interested.
The mount is a short run production by RyokuRob.
I've never seen another one.
6. How low does this go? Very.
It put me at 6'1" a good 3" below the roll bar
7. Use: It was used for about 6 track day weekends.
Good support with harnesses.Install thread: http://forum.miata.net/vb/showthread...hlight=infinit