WTS BCM20 DDOmega12 BCG $575 for all or will separate

over 2 years ago
WTS BCM20 DDOmega12 BCG $575 for all or will separate
Price
$575.00
Brand
Omega
Seller
glazer1972
Available on
M4 Carbine
Description

Early Unmarked BCM Std. 20 Govt Profile Upper Receiver Group w/ Std. Mil Spec Charging Handle. $300 Shipped
Daniel Defense Omega 12.0 Rail w/ four 7 long low profile rail covers. $200 Shipped
GTS/Denny's Guns Super Duty M16 BCG. $100 Shipped
Front sling swivel has been removed from FSB. About 200 rounds fired through it. Never run hot.
Troy Rear Sight is NOT included. I've had some interest in the upper minus the rails. If anyone is interested in the DD Omega 12.0, the bcg, or the upper by itself let me know.
All for $575 shipped
For the guys that never heard of the GTS/Denny's Guns Super Duty BCG. The me was Denny @ Global Tactical.
The SUPER DUTY BOLT CARRIER GROUP is built by hand by me from the finest components for those individuals who want a drop in Bolt Carrier Group that exhibits the highest level of reliability.
The components used are as follows:
M16 MILSPEC PARKED BOLT CARRIER. INTERNALLY CHROMED
YOUNG MFG INTERNALLY CHROMED GAS KEY GRADE 8 GAS KEY SCREWS
CMT MILSPEC FIRING PIN
CMT MILSPEC CAM PIN. MOLY PLATED
CMT FIRING PIN RETAINING SPLIT PIN
CMT "CM" MARKED MPI BOLT COMPLETE
SHOT PEENED EXTRACTOR
CHROME SILICON EXTRACTOR SPRING
BRAVO CO.CORRECT DUROMETER BLACK BUMPER
BRAVO COMPANY 4 COIL EXTRA STRENGTH CHROME SILICON EXTRACTOR SPRING
The bolt carriers are shipped stripped. They are assembled by me personally. I check the keys on our granite block to make sure they are flat and true. I then de-grease the keys, screws and the mounting area on the bolt carrier.
Red Locktite is then applied to the bottom of the carrier key to insure a perfect gas seal. Red Locktite is then applied to the cap screws. The carrier key is then put in place and the screws are properly torqued tight.
The next step is to side stake the bolt carrier key. After staking the top of the key is peened to remove any burrs that may have occured in the staking process.
The ejector is removed so the factory ejector spring can be replaced with the Chrome Silicon ejector spring and the extractor reinstalled.
The final step before reassembly of the bolt is to install the Chrome Silicon extractor spring, black bumper and then replace the upgraded extractor assembly into the bolt.
20150507_072625 by glazer1972, on Flickr
20150507_072646 by glazer1972, on Flickr
20150507_072657 by glazer1972, on Flickr
20150507_072716 by glazer1972, on Flickr
20150507_072753 by glazer1972, on Flickr
20150507_072741 by glazer1972, on Flickr