"ultimate" AR-15 - Noveske - Leupold - priced to sell

over 3 years ago
"ultimate" AR-15 - Noveske - Leupold - priced to sell
Phoenix Arms
Available on
Northwest Firearms

Stll breaking in...Round count is exactly 50 (only fired Black Hills)
This is sub moa "tack driver".
First off a little back story:
Started life as a factory assembled PSA / FN 18" 223 wylde upper with a 15" Midwest Industries SS15G2 free-float rail - Magpul moe fixed riffle stock / PSA lower. A trip to Curts is where the biggest change occurred. They had a Noveske 18" ss barrel
(made when John was still with us)....and now on to the post.
As new AR-15 (round count is exactly 50 on the barrel ) total round count is under 150. PSA factory upper / lower with proper upgrades
(original barrel has been sold)
Noveske 18" Stainless Steel lightweight contour 5.56mm barrel
(installed at Curts)
1 in 7" twist, improved polygonal rifling, extended feed ramps, bead blasted finish and has the intermediate gas system. (You can shoot 223 or 5.56 ammunition).
PSA F/A bcg with BCM bolt (new bolt installed when new barrel was put on). Probably not necessary as round count was under 100 but I felt better lean on the side of caution.
Noveske (not marked) mil-spec charge handle
Troy 5.56 Medieval flash suppressor
Midwest Industries SS15G2 15" free-float key mod rail
Magpul moe riffle buttstock
Leupold VARI-X III 3.5x10-40 1" scope with target turrets
American Defense AD-Recon SL 20 moa qd mount
Ice Arms Nickel Boron EXO hammer (makes trigger perfect) /
original hammer included
Ics Arms Enhanced Hexagonal
trigger guard
/ original trigger guard included
Odin Works XMR extended magazine release
Hogue "monogrip" pistol grip
4 magazines (total) included -
one D&H 5 round, one D&H 10 round, one new in package Magpul 30 round pmag and one new in package Magpul 40 round capacity pmag.
One key mod rail section and no name bi-pod is included
The factory assembled PSA upper / lower are both forged per mil-spec 7075-T6 material, T marks (upper), and black hard coat anodized per mil- 8625. The upper also has M4 feed ramp cuts.
Because I started with factory assembled parts this build cost me about $2,200 dollars. One would save a couple hundred if not done this way but still would set you back much more than I'm asking for this one.
$1,200 dollars cash for complete package
(not separating...please don't ask) - selling due to bills.
Additionally I won't respond to low-ball offers.
Located in rural Hillsboro
Can meet up at Sportsman warehouse off 185th and highway 26