WTS Custom build AR-15 Free float long rail with red dot, SGV area

about 3 years ago
WTS Custom build AR-15 Free float long rail with red dot, SGV area
Phoenix Arms
Available on
Cal Guns
to do PPT.

This is a custom build 5.56/223 AR-15, upper is made by Harden Arms
Strip lower is by Delaware Machinery, and LPK is Anderson Arms, features Stainless trigger and hammer. Mil spec buffer tub and Black Hawk butt stock with sling swivel already attached!! Bullet button already installed, will come with one magazine.
Also comes with generic ebay red dot sight (holds zero fine and bright)
I have put less than 100 round through her (With 0 problems), carefully cleaned after the single range session. Only reason I'm selling is that I need to fund another project, hate to see it go.
I'm asking $950 or OBO, please PM or reply
I am located in San Gabriel area and Turners in Pasadena is the best location to do PPT.
Cash only, buyer pays all transfer fees.
Thanks for looking!!!
Below is a bit more description about the upper
-Hardened Arms M4 Feed Ramp Flat Top Receiver
-Black anodized mil-spec finished upper receiver
-Feed ramps for increased feeding reliability on barrel and upper
-Laser etched T-Marked upper receiver
-Chrome Moly 5.56 High End Barrel
-Melonite Coated barrel (Harder and more durable than chrome lining)
-1/9 Barrel Twist (1/7 available for purchase here)
-Chambered in 5.56 NATO (will also fire .223 ammo)
-16" M4 Profile barrel with M4 Extension
-.750" diameter at gas block
-1/2x28 threaded muzzle/barrel
-Low profile gas block
-Barrel dimpled to secure gas block
-Carbine length gas system
-A2 flash hider
-Tactical Quad Rail free float 15" handguard with end cap
-Full Auto Profile Melonited BCG (Harder and more durable than chrome lined BCGs)
-Milspec Charging Handle